亚洲欧美二区绝色浪潮性色-国产亚洲欧美在线专区免费黄片在线看-日韩欧美久久免费-青草久久久国产线免观蜜芽,国内精品九九久久精品,日韩精品一区二区三区射精,天天摸夜夜摸夜夜狠狠摸





        



        


            

        

        

 
        

        
    
        
    
        
    The performance characteristics of friction materials determine the manufacturing process

        
    
        
    
        
    Published:

        
    
        2022-11-23
        

        
    
        wangda
        


        

        
    
        Phenolic resin is an important component in the structure of friction materials. It is important to understand its technological properties. The molding process can be divided into casting and molding. Phenolic friction materials are produced by hot pressing process. There are two reasons for phenolic pressure plastics curing under heating and pressure. The first is the fluidity factor of pressure plastics. In the production of friction materials, in order to make the friction materials obtain the required friction properties and mechanical strength, the amount of filler and fiber reinforced materials usually accounts for 80%~90% of the ingredients in the formula, while the amount of resin adhesive only accounts for 10%~20%, so the fluidity of the pressure plastics is relatively poor. If the casting molding process is adopted, the molded products cannot be obtained by filling the wood cavity with pressure plastics.
        


        Generally, we must use the molding process of heating and pressurization to make the pressurized plastic flow in the mold cavity heated to the curing temperature (170~180 ℃) under a certain pressure, fill the mold cavity, and be cured by heat, so as to obtain the cured molded products. The second is that the phenolic resin in the pressure plastic undergoes further polycondensation at the curing temperature, gradually changing from linear structure or branched chain structure to three-dimensional cross-linked network structure, and finally achieving curing. In this process, the resin will release water and other low molecular substances, which will generate large steam pressure at the molding temperature (150 ℃). If they escape from the surface of the molded products, the products will be damaged and discarded. Therefore, the products in the mold need to maintain high molding pressure before fully curing.